Description
This Vast Satellite Dish Portable Kit will allow you to receive Foxtel (with your own Foxtel decoder) and/or Vast TV satellite services. The 65cm Diameter is sufficient for most of the eastern seaboard and inland areas.
Satellite Dish
Patented double rolled edge. Galvanized steel reflector. Charcoal color, powder coat finish. Stainless steel hardware. AZ/EI mount type with 360° Azimuth Alignment. 40mm LNB clamp included. Now available with a quick-release detachable LNB arm for portable use.
- Reflector: Offset
- Aperture Efficiency: >80%
- Horizontal Axis: 65cm
- Vertical Axis: 74cm
- Gain @ 12.5GHz: 37.6dB
- Focal Length: 32.5cm
- F/D Ratio: 0.5
- Elevation Alignment: 15° – 85°
- Pole Diameter: 30 – 48mm
- Operation Wind: 80Km/h
- Survival Wind: 180Km/h
LNB
For use with your satellite dish, this is a dual output, dual polarity (horizontal/vertical) LNBF that receives the signal for Vast TV and Fox. High Gain Dual Polarity 10.7GHz LO Ku Band LNBs. Higher gain and new ultra-compact design.
- Outputs 2
- Input Frequency Range 11.7GHz to 12.75GHz
- Output Frequency Range 1000MHz to 2050MHz L.O. Frequency 10.7GHz L.O.
- Accuracy Initial Accuracy (@ 25°C): ±1MHz L.O.
- Temperature Drift -30oC to +60oC: ±1.5MHz L.O.
- Phase Noise @ IKHz Offset: -60dBc/Hz @ I0KHz Offset: -80dBc/Hz @ I00KHz Offset: -95dBc/Hz Noise Figure @ 25°C: 0.7dB (typ.)
- Conversion Gain @ 25°C: 60dB to 72dB
- Image Rejection 40dB min.
- Output VSWR 2.0:1 Cross-Pole Isolation 20dB min.
- Supply Voltage Vertical Polarisation: 10.5V to 14.5V Horizontal Polarisation: 15.5V to 21.0V Current consumption 100mA max. 115mA max.
- Load Impedance 75Ohm Reflector Type Offset F/D Ratio 0.6 Feedarm
- Mount 40mm Ø
- Storage Temperature -30°C to +60°C
- Output Connector 75Ω F type
- Gain Flatness 6dBpp (typ.) / entire band 1.5dBpp (typ.) / 27MHz L.O.
- Spurious -30dBm max.
Portable Travel Mount
High quality solid construction with bubble level and adjustable wing nuts also peggable to secure to the ground. (optionable)
VAST Satellite Receiver ALTECH DSD 5000 RV Twin Tuner
1-year Manufacturers warranty with support and solutions. New model with led channel display! the vast service is pretty much Australia-wide, grab this box and get access.
- Altechs DSD 5000 RV Compact – only 225 L x 42 H x 135 D mm, perfect for caravans
- HDMI Cable/ remote control/smart card all included.
- 12-volt adaptor FOR THE ALTECH DECODER
- Ready to record – support and ready to convert into a PVR unit with an external USB2.0 storage device
- Twin Tuner function – with dual DVB-S2 tuners you will never miss your favorite show again
- Made for Australian conditions – ruggedized design and construction to suit the harsh Australian environment
- Dual Power operation (12V DC/ 240V) is perfect for homes or caravans and motor homes
- Remote control IR extender on F Connector – for discreet installation. (optional)
- Accesses free-to-air TV channels and Radio stations from almost anywhere in Australia
- Hybrid Broadband TV (HbbTV) Australian Profile ready with all key software features to support Freeview Plus
- Decodes High Definition HEVC / MPEG 2 & MPEG4 and Dolby Digital audio
- Closed caption subtitles
- The electronic Program Guide (EPG) simplifies program access
- Software developed in Australia and optimized for Australian viewers
- Secure Boot Processor Core
- IRDETO secure silicon conditional access
- Firmware is upgradeable via USB and Over The Air
- Altech VAST certified – and built for Optus Aurora Digital platform.
- The magic eye is available separately
- Now with Christian tv GOD TV.
Also, the backup support for this product is exceptional, fast, and efficient. You only need to register the box with vast and you are off. Support is a phone call away.
Tester
The SatKing SK-3200 is a digital satellite Finder specially designed for VAST satellite TV. Being MPEG 4 the unit has been pre-programmed with the VAST paraFinders pre-set making the Finder very easy to use. If the other Finders you find just say digital they are not MPEG4 so they will not last. Simply plug the unit into the dish and use the signal level bars to align your dish once the level bars go green and the signal beeper is sounding the dish is aligned correctly and you are on the correct satellite. Then plug the antenna cable into your vast receiver or Foxtel STB and it will scan the channels in for you. The unit has a built-in high-power battery so the unit does not need to be connected to the VAST receiver to be used. Unlike many other lower-priced Finders on the market with this Finder, you can actually receive VAST transponders. For many other mid-lower cost Finders you are actually just receiving the signal from the MPEG2 format and this could end anytime rendering your Finder useless. Special Note: All VAST services are MPEG4, there are no VAST MPEG2 services. If you have Foxtel and think this Finder sounds perfect for you well it is, you can simply align your dish on the VAST settings or simply select TP 3 in the sat setting menu and the unit will receive the actual Foxtel signal.
Features:
- VAST Compliant
- MPEG4
- 2.4” Colour LCD Screen
- Built-in Speaker
- Built-in Light
- Signal buzzer
- Built-in Compass
- Satellite Alignment Tool built-in
- 800MAh Lithium-Ion Battery
- Software Upgrade via mini USB
- Compact Size
- Signal Too Noise Display
- BER Display
- dBuV Display
- dBm Display
Specifications:
- Signal Level: 25 to -65dBm
- L.O: 10,000-12,000 GHz
- Satellite Input: 1x F-Type
- LNB Power: 13/18V
- 22KHz: Yes
- Diseqc: No
- Voltage Input: 12VDC
- Symbol Range 2-45,000
- Video Encoding: MPEG2/MPEG4
- Audio: MPEG-1 Layer II , MPEG4 HE-AAC v2
Connections:
- 1x F-Male Sat Input
- 1x Mini USB
- 1x 2.1mm DC Jack
Package Includes:
- 1x Finder
- 1x 240v/12V Power Pack
- 1x Case, 1x Strap
- 1x Battery 800MAh
- 1x Gift Box
The Cable
The Vast Satellite Dish Kit comes with 15 meters of pre-terminated RG6 Quad Cable which is for the vast system (1 Cable needed) if you require more cable please add 15 meters in checkout with a note to pre terminated. 15 meters or rg 6 quad cable, + fly lead.
